Digi XPress Wireless Ethernet Bridge
900 MHz Wireless Ethernet Bridge
- Easy-to-use web interface simplifies configuration and remote troubleshooting
- Check packet success and signal strength with the web interface
- Outdoor line-of-sight range of up to 15 miles (with high gain antenna)
- AES encryption, FIPS 197 and optional FIPS 140-2 provide secure communication
- Built-in NAT supports multiple IP client devices
- Frequency agility ensures reliable connection between radios
- Monitor RF interference with built-in spectrum analyzer
The XPress Wireless Ethernet Bridge replaces costly wiring with a solution that can wirelessly connect industrial PLCs, digital signs, security cameras, access controllers and more. With a range of up to 15 miles, the ability to transmit through as many as 10 standard walls, a 1.5 Mbps data rate, and the added range and capabilities of the 900 MHz band, the easy-to-use, long-range XPress Wireless Ethernet Bridge communicates where Wi-Fi and other wireless data products fall short.
Performance
- Indoor/Urban Range
Up to 1000 ft (300 m) w/ 2.1 dB dipole antenna
Outdoor/RF Line-of-Sight Range
Up to 2 miles (3.2 km) w/ 2.5 dB dipole antenna, Up to 15 miles (24 km) w/ high-gain antenna
Transmit Power Output
125 mW (+21 dBm), 4W EIRP w/ 15 dBi antenna
Throughput Data Rate
935 Kbps
RF Data Rate
1.536 Mbps
Receiver Sensitivity
-97 dBm (@10e-4 BER)
Features
- Supported Protocols
TCP/IP, Rockwell (RSLinx EtherNet/IP, CSP), Modbus/TCP
Browser Management Tools
QoS statistics, Network settings, Spectrum analyzer, Firmware upgrading
Data Connection
10/100Base-T RJ-45, Auto MDI/MDIX
Interference Immunity
DSSS (Direct Sequence Spread Spectrum)
Encryption
128-bit AES, FIPS 197/NIST certified (optional FIPS 140-2)
Radio Channels/Bandwidth
12 channels (6 in international version) with 2.0833 MHz spacing and 1.75 MHz occupied bandwidth
Frequency Band
ISM 902-928 MHz (915-928 MHz international version)
Frequency Agility
Radio channel automatically selected and adaptively optimized
Manual Frequency Mode
Channel selected with DIP switch or web browser interface
Status LEDs
Power, RF TX/RX, Ethernet link, channel, link quality
Error-Correction Technique
Sub-block error detection and retransmission
Adjacent-Band Rejection
>60 dB - SAW receiver filter attenuates cellular and pager interference
Regulator Type
Switching regulator
Antenna Connector
RF RPTNC female
PoE (Power over Ethernet)
Proprietary system included
Subscriber Units
Up to 16 active (63 total) per access point
Serial Number Based Mating Protocol
Yes
Dimensions (L x W x H)
7.9 in x 3.6 in x 2.4 in (20.0 cm x 9.1 cm x 6.1 cm)
Weight
415 grams
Power Requirements
- Power Consumption
Transmit: 1.7W, Receive: 0.8W
Transmit Current Draw
9 - 48 VDC Power over Ethernet, 175 mA at 9 VDC, 140 mA at 12 VDC, 35 mA at 48VDC
Power Connector
Use PoE injector, power jack P5-2.1 mm center positive
Environmental
- Operating Temperature
Radio/Enclosure: -40° C to +70° C; POE injector: -40° C to +85° C; Power supply: 0° C to +40° C
Weatherproofing
The XPress Wireless Ethernet Bridge is IP65 rated. The PoE injector and power supply are not weatherproof, and should be installed indoors.
Regulatory Approvals
- ETSI (Europe)
N/A
Kunder som tittade på denna vara tittade också på